Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.[5] Jack Bracket
Be careful not to break them. (S-4)
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2)
1-3. Disconnect Connector (CN1505), and remove
the Front Assembly.
2. When reassembling, solder wire jumpers as shown[6] Front
in Fig. D8.Jack CBA
3. Before installing the Deck Assembly, be sure toJack Earth Plate
place the pin of LD-SW on Main CBA as shown inFig. D3
Fig. D8. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D8.(S-5A)
CN501
(S-5B)
CN601
(S-1)(S-1)(S-5A)
[7] DVD
Mechanism
&
DVD Main
CBA
Assembly
[1] Top Cover
(S-1)
Fig. D1
(S-2)[4] Radiation Sheet
(S-2)
[3] Front (S-3)
Bracket
Fig. D4
(L-1)
(L-1)
CN1505
[2] Front
(L-2)Assembly
(L-1)Fig. D2
1-6-2E9710DC |